Kuzma AIR LINE 130401 User Manual

Instruction manual KUZMA AIR LINE AIR BEARING T

5.0. Tonearm Setup: Note: See also 4.4.3.On the tonearm remove the protective shaft cover and the security wire which has restricted movement of the

5.3. Adjustment of tracking force:The counterweight is made from two parts. Rotating the counterweight position from one red point to another, chang

Fig. 8 Protractor – position from topMove the cartridge along the headshell to such a distance, that the tip of the diamond (needle) is on the line on

Now you can start playing LPs. On a spinning record gently lower the needle into the first groove. When the needle touches the record it will move i

To make VTA adjustment easier, you can rotate the ring while holding the main knob to adjust the zero starting point on the knob. This knob can rotat

7.0. Damping: A damping system, consisting of a paddle, damping trough and silicone oil is fitted at the rear of shaft.The paddle is fixed on to the t

8.0. Zero Switching kit (optional):The function of the “zero switching kit” is to eliminate the noise of the compressor switching ON and OFF being hea

Protect the cartridge. Do not slide the bearing without compressed air. Allen key 4 mm will release the top screw of the blocking plate, which is at

10.0. Troubleshooting:NOTE: Check our web site for frequently asked questions (FAQ) for some more answers. See also appendix o

10.5. Compressor does not start:Check the mains electricity. Compressor was overheated and overheating protection switches it off. Overheating protec

KUZMA LTDINSTRUCTION MANUAL FOR AIR LINE tonearmThe Air line tonearm is a very precisely engineered piece of equipment. However

1.0. General description:Main outer box contains two inner boxes. One box contains the compressor with oil, PVC double drain bottles and the second bo

2.0. Unpacking:Fig. 1 Compressor with “Double drain bottle system.” 2.1. Compressor box:Open the box and lift up the compressor by the handle. It is

3.0. Setup description:Do not slide the tonearm bearing unnecessarily without compressed air!Do not tilt the compressor while it contains oil! For tra

4.0. Air supply Setup:4.1. Compressor:Note: The working cycle of the compressor takes around 2 minutes building up pressure from 6 to 8 bars and then

Remove the small plastic cap from the metal input tube at the head of compressor, which is onthe side wall marked “oil”. Fig. 4. Fix the nozzle with

At the rear of the compressor is a glass bubble which will show the correct level of oil when the compressor is not working for half an hour. Fig. 3.

4.4. Air pressure Setup:Note: keep valves on air tube supply and tonearm in the closed position. All tubes must be connected.4.4.1. Compressor ON:Plug